Installation Steps Of LED Street Lights

How to install LED Street Light? Phoebus as an over 20 years LED Street Light Supplier, help instructed the installation works of led street light with our professional technique. Now let us make a brief introduction of the LED street light installation.

A completed set of LED Street Light is made up of LED Light, Cables, lamp-post and foundation, etc.

The installation steps of LED street lights can vary depending on the specific manufacturer or model, but here is a general guide:

1. Planning and Design: Before starting the installation process, it's important to have a thorough plan and design for the LED street light installation. This includes determining the number and location of the street lights, understanding the specific lighting requirements for the area, and ensuring that all necessary permits and approvals are obtained. Phoebus could supply the proposal addressing the site condition with Dialux simulation.

2. The Foundation Casting.

Please excavate the foundation ditch in the confirming site, the foundation ditch should be deeper if the soil texture is soft among 1m area of the earth surface. At the same time, please confirm and protect excavation site and other facilities, such as cables, pipes, etc. Put the embedded part into the foundation ditch, and put one end of steel wire tube in the middle of embedded part. Keep the embedded part, The foundation and land area should have the same horizontal plane. Then use concrete to cast and fix the embedded part. Please continue to stir even during the casting, to guarantee the sealing and fastness for whole of embedded part. Clean the residue on the position plate in time after completing the construction, the LED street light can start to be installed after concrete being complete solidification (Usually it is about 4 days, sometime it is 3 days if whether is well).

3. The Installation of LED street light, Lamp poles.

1) Mounting the Lights

Please threading lamp wires out from lamp arm, outgoing some lamp wire to install lamp head. Support the lamp-post, threading another wiring terminal out from reserved hole of lamp-post, and install lamp head in another wiring terminal. Use screw to fix lamp-arm and lamp-post.Make sure that the lights are properly aligned and securely fastened to ensure stability and proper illumination.

2) Lift the Lamp-pole.

The fastness situation of every components must be carefully checked before lifting lamp-post, check if lamp head has any deviation, and make moderate adjustment. Slowly lift lamp-post, avoid steel wire rope of crane to scratch the lamp. Slowly put down lamp-post and rotate the lamp-poles to adjust its orientation. After the ring flange being into foundation, gradually sheathe flat gasket, spring pad and nut, then use wrench to tighten nut and fasten lamp-poles.Remove the lifting rope, and check if having any incline.

3) Electrical Connections.

Connect the wiring of the LED street lights to the electrical power source. This involves connecting the live, neutral, and ground wires using appropriate electrical connectors or terminal blocks. Ensure that all connections are properly insulated and protected against moisture and other environmental factors.

4. Testing&Adjustments:

Once the installation is complete, it's essential to test the LED street lights to ensure they are functioning correctly. Switch on the power and check if all the lights are illuminated, and that they are providing the desired amount of light and coverage. Inspect the installation site and the street lights for any issues or defects. Make any necessary adjustments to the alignment or positioning of the lights to optimize their performance and coverage.

5. Maintenance and Operations:

Set up a regular maintenance schedule for the LED street lights, including cleaning, inspecting for any damage or wear, and replacing any faulty components. Follow the manufacturer's guidelines for maintenance and refer to the specific warranty information.

Remember, it is always recommended to consult with a professional electrician or contractor experienced in LED street light installations to ensure safety and proper installation practices are followed.

And Phoebus is at your service all the time.